- Raise the garage door up. Using the flat-head screwdriver, pry the old trim off the doorjamb.
- Using your hammer, remove any nails that may be remaining. Use the claw end of the hammer to remove any residual caulk left behind by the old trim.
- Sand down the jamb by hand using a sheet of rough-grit sandpaper. This will help ensure a smooth application.
- Close the garage door fully. Start at the top and measure the opening. Using a miter saw, cut a piece of trim to size.
- Have a helper hold one end of the trim to the header while you hold the other end. Position the trim by allowing the weather strip to slightly bend over the garage door. Tack the trim into the header with the finishing nails spaced about 12 inches apart.
- Measure both jambs from the ground to the trim, and cut each piece of trim for the appropriate jamb.
- Line up your jamb trim even with the top trim, and tack into place using the finishing nails.
- Make sure that the weather strip is even all the way around the opening. Finish nailing the trim into place.
- Put the caulk in the caulking gun and apply a small bead between the trim and the door jamb. This will help in keeping moisture from between the trim and wood.
Allegedly... the above procedure is how this whole thing will work.
Seems easy right?
Somehow I don't think that this will go as smoothly as it describes.
- MATERIALS LIST: lots and lots of wood trim, nails, caulk, sandpaper
- ESTIMATED COST: Don't even want to think about it.
- PROJECT DETAILS: SEE ABOVE
- PROJECTED TIME LINE: 2 weeks
- WORKERS FOR PROJECT: 2 (just honey bunny and me)
The past few years we have noticed the trim around our garage doors was in need of repair. By the end of last summer, the wood trim was in sorry shape and must be tackled this summer. AHH... the joys of home-ownership.
No comments:
Post a Comment